Meco Midget vs Smith Little Torch. Another welding question. I'm looking for a torch to use specifically for aluminum and sheet metal. I really don't have a need for a Henrob, as I already have a plasma cutter.
I've always wondered whether the "hobby" mig welders were any good. The challenge for the Clarke 90EN review was to see whether it would weld at all, and then to test out the manufacturer's claims and see if it could really weld up to 4mm thick steel. Actually the answer was a fairly straight no see the calculator for predictions , but the machine itself was reasonable nice to use. The page is included here as it includes some tips on joint preparation that will increase the thickness capability of small welders. That's just 90 amps.
Thermal spraying techniques are coating processes in which melted or heated materials are sprayed onto a surface. The "feedstock" coating precursor is heated by electrical plasma or arc or chemical means combustion flame. Thermal spraying can provide thick coatings approx. Coating materials available for thermal spraying include metals, alloys, ceramics, plastics and composites.
Mmm.Stay Just Like That While I Lick Your Pussy \u0026 Ass Then Tongue Fuck Both Hot Holes Then Slip My Big Black Cock Deep Inside Your Ass As I give It Deep Long Hard Storks \u0026 Thrusts Sliding In \u0026 Out Of Your Ass Until I Fill It Up With My Hot Warm Creamy Load Deep Inside